
1. OziExplorer Configuration for Moving Map -
Garmin Interface setting in the
GPS set to Garmin Mode (outputs PVT data)
Please note
-
The GPS must be turned on when Moving Map in OziExplorer is started as
OziExplorer needs to send commands to the GPS.
On the File menu choose the Configuration option, this will open the
configuration dialog.
Select the GPS tab.
Select the GPS Make as Garmin
Select the GPS Model to match the model of Garmin GPS you have. If you model
is not listed then select the "Other Garmins" setting. The GPS parameters can be
adjusted to match the specifications for the model of GPS (refer to the GPS
manual for this).
The
GPS NMEA Output Datum
is ignored.
Select the
COM tab
on the Configuration dialog.
Set the
Com Port
number that you have connected the GPS to.
Set the
Parity
to None.
Set the
Stop Bits
to 1
The
NMEA Baud Rate
is ignored..
Make sure the
Use PVT for Garmin instead of NMEA
Checkbox is
ticked
The
Serial Port Driver
should be set to Driver 2 (this is the default)
Auto Pilot Output settings can be ignored.
2. OziExplorer Configuration for Moving Map -
Garmin Interface setting in the
GPS set to NMEA Out Mode
On the File menu choose the Configuration option, this will open the
configuration dialog.
Select the GPS tab.
Select the GPS Make as Garmin
Select the GPS Model to match the model of Garmin GPS you have. If you model
is not listed then select the "Other Garmins" setting. The GPS parameters can be
adjusted to match the specifications for the model of GPS (refer to the GPS
manual for this).
Set the
GPS NMEA Output Datum
to the same datum the GPS is set to,
Garmins always output the positions in NMEA data in the datum the GPS is set
OziExplorer Help Contents
Comentários a estes Manuais