Brunton Multi-Navigator Especificações descarregar pdf (Página 215)

The PgUp/PgDn keys zoom the map in and out.

There are 50, 100 and 200% zoom levels available on the right click map menu.

There are +

zoom buttons on the toolbar.

There will soon be a version released which has specific zoom buttons which can be added to the

user toolbar, including a "Full" zoom button.

When I use the Zoom there is a considerable delay until control is returned.

This is an unavoidable problem when using very large BMP image files for the map and your system

doesn't have enough memory. In this case Zoom is unusable with very large files, reduce the size of

the files if possible. This problem does not occur with tiff files which use a different method for

zooming. Tiff files can only be used by the registered version.

I calibrated my map but waypoints do not plot on the map when I download them from the

GPS or load them from a file even though they should.

Very likely the map calibration is wrong. Make sure you have set the E/W or N/S fields to specify

negative positions of latitude and longitude. Make sure the positions are in Degrees and decimal

minutes. If using UTM make sure you specify the correct zone and use the N/S field to indicate if you

a north or south of the equator.

All waypoint positions I download plot slightly off from where they should by the same

amount, why is this.

Datums, Datums, Datums. A mismatch of datums cause this sort of affect. If you only have the

shareware version and have a Lowrance or Eagle make sure the GPS has its datum set to match the

Map you are using when you collect the data.

Note

some Lowrance and Eagles now output all data

in WGS84 so check out exactly what your GPS does.

If you have a Garmin it will always download in WGS84 no matter what datum you set the GPS to so

with the shareware version there is nothing you can do.

To fix this problem you must have the registered version so datums can be set for the Map and GPS.

But before you set Datums read the

Datums

help.

When I print the map or save it as a BMP or PNG file the tracks or routes are not shown even

though I have them loaded.

The tracks or routes will only be printed or saved on the map if they are visible on the screen map

(not just loaded), this is a sort of "what you see is what you get" approach.

I have a track loaded and displayed on the map but when I start to use moving map the track

seems to disappear even though the show tracks button is down.

The track you have displayed would be loaded into Track 1. When you start using moving map and

display the Moving map Control this sets up its own parameters for Track 1, you may have it set to

only display a certain number of track points as a tail from your position.

When I add the symbols to the symbols directory in OziExplorer they do not appear in the

symbol selection for Waypoints.

Page

215

252

OziExplorer Help Contents

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 251 252

Comentários a estes Manuais

Sem comentários

Brunton Multi-Navigator Especificações Página 215

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de navegação Brunton Multi-Navigator