Brunton Multi-Navigator Especificações descarregar pdf (Página 159)

CPA Alarm -

On show the CPA graphics if the ship is generating a CPA alarm.

CPA Graphics Range

Specify the range using the specified units.

Auto Pilot Output

The Auto Pilot Output option has been provided for experimentation purposes only, do not use it

to guide your vehicle without supervision.

The functionality has not been tested to a satisfactory degree in this version of OziExplorer.

The Auto Pilot output option is turned on using the options on the Comm tab in the Configuration

dialog.

Outputs the Standard NMEA sentences which can control an Autopilot. The sentences output are

$GPRMC, $GPRMB and $GPAPB. You must check if these sentences are compatible with your

Autopilot.

The sentences being output can be viewed by selecting the

Show NMEA Output to Autopilot

option on the Navigation Menu. You must be in active moving map (tracking) mode and also be

navigating for the outputs to be valid.

The sentences are output each time a sentence is received from the GPS.

The output also functions when using the NMEA simulator in OziExplorer so this could be used for

testing its operation.

The NMEA strings only contain valid navigational information if you are navigating along a route or

to a waypoint. Otherwise the parameters in the strings are empty.

The most common connection is where the GPS and Autopilot share the same serial port, this is a

diagram of a typical cable connection.

Waypoints

Waypoints are used to mark fishing or hunting locations, landmarks, boat ramps, and virtually any

other point of interest.

If you have a compatible make and model of GPS waypoints can be uploaded/downloaded to or from

the GPS.

Page

159

252

OziExplorer Help Contents

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 251 252

Sem comentários

Brunton Multi-Navigator Especificações Página 159